ok now i got the pan in ,,,not 100 % sure how it will work out the torque spec for the pan on all data says 80 inch lbs the fel pro gasket instructions says 8 ft lbs ,,,my torque wrench wouldnt fit without an extension and the wrench was set at 45 inch lbs went through all the bolts 2 times just hope its enough torque the 80 inch lbs made me nervous ,,,but i guess i can always get them tighter if needed ,,,,,, my next concern is the gasket overlap on the pan lip near rear main area is barely overlapped on one side due to pan stamping just hoping that will be ok other than that it was somewhat a pain in the ass